_______________________________________________________________
| Summary: | Installing APM & POWER.EXE with QEMM 7.03 |
| Date: | September 29, 1995 |
| Product: | As listed |
| Additional Information: | None. |
When installing QEMM 7.03 on systems which support APM in the BIOS, it is important to be sure that the POWER.EXE device driver is loaded in CONFIG.SYS. Lack of the POWER.EXE driver will cause the Toshiba power saving features to be disabled (Display Auto Off, HDD Auto Off, etc.) You will also need to exclude the memory area used by the power saving features and Resume.
T386.EXE (available from the Toshiba BBS and Toshiba CompuServe Forum) is still required for systems which support the Pop-Up Window.
Below is an example CONFIG.SYS from a T3400CT:
DEVICE=C:\QEMM\QEMM386.SYS RAM X=E800-EFFF
DEVICE=C:\QEMM\QDPMI.SYS SWAPFILE=DPMI.SWP SWAPSIZE=1024 BUFFERS=10,0
FILES=60
DOS=UMB
LASTDRIVE=E
FCBS=4,0
DOS=HIGH
DEVICE=C:\DOS\POWER.EXE
STACKS=9,256
SHELL=C:\DOS\COMMAND.COM C:\DOS\ /P /E:2048
Here is a additional CONFIG.SYS using Stealth mode and Doublespace:
DEVICE=C:\QEMM\DOSDATA.SYS
DEVICE=C:\QEMM\QEMM386.SYS RAM X=E800-EFFF ST:F DBF=2 R:1 I=B000-B7FF
DEVICE=C:\QEMM\DOS-UP.SYS @C:\QEMM\DOS-UP.DAT
BUFFERS=30
FILES=30
DOS=UMB
LASTDRIVE=E
FCBS=4,0
DOS=HIGH
DEVICE=C:\DOS\SETVER.EXE
DEVICE=C:\DOS\POWER.EXE
STACKS=0,0
DEVICE=C:\QEMM\ST-DBL.SYS
SHELL=C:\COMMAND.COM C:\ /P
Toshiba America Information Systems Inc. (" TAIS ") shall not be liable for damages of any kind for use of this information, Which is subject to change without notice. Copyright 1994, 1995 TAIS.